A spring is a wear part with a number on it. Ten thousand cycles, then it breaks.
We are a matching service, not the contractor. We route spring and cable work to licensed garage door companies serving Fairfax County, and you contract with the firm you pick. Springs and cables are the two parts that hold a door up, and they are the two parts a homeowner should never touch. A residential torsion spring stores enough energy to injure or kill when it lets go.
| Type | Where it sits | How it works |
|---|---|---|
| Torsion | On a steel shaft above the opening | Twists to store energy, lifts through drums and cables |
| Extension | Above the horizontal track, one each side | Stretches along the track through pulleys |
Overhead Door describes torsion springs as the smoother and safer of the two, and notes that extension springs are mounted in pairs and require safety cables. The cable is the difference between a broken spring and a broken spring that takes a windshield with it. If your door has extension springs and no cable running through the middle of each spring, that is the first thing to add.
Torsion systems usually carry one or two springs on the shaft. When one of a pair breaks, both get replaced, because the second has taken the same cycles and is close behind.
One cycle is one open plus one close. Overhead Door rates standard residential springs at about 10,000 cycles, which is 7 to 10 years at two to four cycles a day and 3 to 5 years at six to ten. High cycle torsion springs rated at 20,000 to 25,000 cycles are available for a house where the garage is the front door.
That last point matters more in a townhouse than in a detached garage. A family that parks two cars, runs a stroller in and out, and uses the garage for the recycling and the extra freezer will pass six cycles a day without trying. The standard spring is then a three to five year part, not a ten year part. Ask for cycles per day before accepting a standard rating.
Published prices sit close to each other: Home Depot lists springs at $250, and Fixr reports a national average of $250 for a torsion spring replacement, inside a $150 to $350 repair range. A high cycle spring costs more than a standard one, and a two spring door costs more than a one spring door.
Steel fatigues faster when it corrodes. Fairfax summers put humidity on the coils for months, and the rust that forms between windings adds friction every time the spring flexes. Overhead Door names surface rust as one of the main causes of premature failure and recommends a silicone based garage door lubricant three or four times a year.
Winter does the rest. Cold makes the metal less forgiving, and the freeze-thaw cycle that defines a Fairfax County January loads and unloads the door hardware daily. Salt brine carried in on the cars settles on the bottom section and the bottom brackets, which is where the cable ends live. The bottom brackets and cable ends are the first parts to fail on a salted door. Most spring failures here are a warm weather corrosion problem that shows up on the first cold morning.
A cable is a wear part too. It runs from a drum at the top of the door down to a bracket at the bottom corner, and it carries the full weight of that side. Frayed strands at the drum, a cable that has jumped its groove, or a bottom bracket that has rusted thin are all reasons to stop using the door.
Replacing a cable means releasing spring tension first, which is why it is not a homeowner job even though the part is cheap. Expect a two cable set with the spring work when the door is old, and expect the technician to check the drums and the center bearing plate while the tension is off.
Cables also explain most off track doors. When one cable goes slack that side of the door drops, the rollers leave the track and the bottom section bends as it lands. That is a cable repair plus a panel repair, and the panel costs more than the cable.
No. A residential torsion spring holds enough stored energy to break a wrist or worse when a winding cone slips, and the winding bars required are not household tools. This is the one repair where the labor is the product.
Yes, on a two spring door. Both springs have the same cycles on them, so the second is close to failing. Replacing one leaves the door unbalanced and usually means a second service call within a year.
Standard springs are rated at about 10,000 cycles. At four cycles a day that is roughly seven years. Ask for the cycle rating in writing and, if the garage is the main entry, ask what a 20,000 or 25,000 cycle spring costs.