A door that will not move is usually telling you which part failed. Read the symptom before you touch anything.
In Fairfax County a dead garage door is one of five things: a manual lock still engaged, a disconnected opener, a tripped circuit, a broken spring, or a cable off its drum. The first three take a minute to rule out and cost nothing. The last two are a licensed repair, and one of them is genuinely lethal to work on.
Start at the door and work outward. None of these checks involves tools or a ladder.
If the door opens a few inches and drops back, or feels like dead weight on the handle, the spring has failed. A torsion spring carries most of the door's weight, so when it breaks the opener is lifting the whole panel stack on its own. The spring is usually visible above the door as a coil on a shaft, and a break shows as a gap of an inch or two in the coil.
Stop pressing the button. Every cycle with a broken spring puts the full door weight through the opener gear, the trolley and the top section, and that is how a spring job becomes a spring, gear and panel job. Do not prop the door open with a ladder or a broom either. The door is held by a cable that is now carrying a load it was not sized for.
The housing stock explains a lot of it. The county splits between 1950s and 1960s brick ramblers, where the spring is often original, and townhouses built from the 1980s on, where a builder-grade spring has been cycled four times a day ever since.
Torsion spring winding kills people. The coil above the door is wound under load and held by two collars. When a winding bar slips out of a collar, it leaves fast and it does not care what is in the way. The same is true of a spring that has been cut or has lost a collar, and of any cable that is under tension.
Extension springs along the horizontal tracks are equally dangerous without safety cables, and a rusted or stretched cable can fail without warning. No page on this site will tell you how to wind a spring, and no responsible company will talk you through it on the phone. If someone offers to, end the call. Quality Garage Doors VA states plainly that spring replacement is not a DIY project and can cause serious injury or death. That is the correct framing.
The technician confirms the failure, weighs the door, checks both springs, both cables and the drums, and replaces springs as a pair. Then the door is balanced, the opener force and travel limits are set to the door rather than to the old spring, and the reversal test is run.
Published local figures give you the shape of the bill. GarageWiz lists a torsion spring replacement at $250 to $800, a cable replacement at $200 to $550, and a door that has to be put back on its track at $250 to $700. Quality Garage Doors VA lists springs at $300 to $750 and cable repair at $180 to $350. Both publish their own numbers, and the spread is the reason to get one written quote rather than a phone estimate.
Where the repair touches framing, the opening size, or a new electrical circuit for an opener, the permit question belongs to Fairfax County Land Development Services at 703-222-0801. A like-for-like swap in the same opening normally does not need a building permit. Check before work starts rather than after.
Usually not. A hum with no movement is either a door disconnected at the trolley, a failed spring, or a stripped drive gear inside the opener. The first is a one-minute fix, the second is a spring job, the third is a gear kit.
Only if it is light and stays where you put it. A door that needs two hands or drops on its own has lost its spring, and lifting it is how people get hurt. Leave it closed.
Same-day service is widely advertised across the county and is realistic for springs and cables on a weekday. Expect an after-hours surcharge outside business hours. F & B Garage Door publishes that surcharge at $75 to $150.