The noise tells you which part is failing. A bang is not the same fault as a grind, and they cost different money.
Garage doors are mechanical, and mechanical things announce wear before they fail. The useful skill is separating the sounds that mean worn hardware from the one sound that means something has already broken. In a county where winter swings between a thaw and a hard freeze, the difference matters more than it does in a milder climate.
Some of it is design. A chain drive rattles, a belt drive is close to silent, and a soft thump as the door meets the slab is the door doing its job. The useful test is change. A door that sounds the way it did five years ago is fine. A door that got louder this month is worn, and the noise is the cheapest diagnostic you will get.
With the door down and the opener unplugged, look along the tracks for a section that has been hit, and look at the rollers for flat spots or a cracked wheel. Put a hand on each hinge and see whether the bolts are snug; a hinge that moves under finger pressure is loose. Look under the opener rail for fine metal shavings, which is the signature of a gear that is being eaten.
Do not reach into the track, and do not put a hand anywhere near a spring, a cable or a drum. Visual checks and a wrench on a hinge bolt are the limit.
A silicone or lithium spray at the hinge points, the roller stems and the torsion shaft bearings is what the hardware expects. Spring coils take a purpose-made spring lubricant, not grease. Grease holds grit, and grit in a hinge turns a squeak into a worn hinge pin.
General-purpose penetrant is a water displacer, not a lasting lubricant, and it will quiet a hinge for a week before the squeak comes back. Cooking oil and engine oil attract dust and drip onto the paint and the slab. None of this fixes a grind, because a grind is a worn gear and no spray reaches it.
A tune-up is a lubrication and adjustment visit: springs, hinges and rollers lubricated, hinge and track bolts tightened, the door balanced, travel limits and force set, and the reversal tested. GarageWiz lists a tune-up and full inspection at under $100 on its current special. That is the cheapest visit on this list, and it is the one that finds the roller before it fails.
Where a part is worn, the published figures are $150 to $450 for a full set of rollers and $150 to $400 for hinge and bracket work at GarageWiz, and $200 to $700 for opener repair once the fault is inside the motor. A broken spring is not a tune-up, and it is priced as a spring pair.
Fairfax makes this worse than the climate alone would. Road salt and grit off the Beltway and Route 50 work into hinge pins and roller stems through the winter, and summer humidity strips the lubricant film off anything that is not sealed. A door that gets one lubrication visit in October lasts longer than one that gets two in July.
A squeal or a rattle is not. A single loud bang followed by a door that will not lift is, because that is a broken spring and the door should not be operated.
No. Grinding comes from a stripped gear or a worn trolley inside the opener, and no spray reaches those parts. It needs a gear kit or a trolley.
Once a year is the usual advice, and late autumn is the right time here. The first hard freeze is when stiff grease and a tired spring show up together.